Dynamic logoTHE DYNAMIC
GROUP

Guides · Updated November 2026

How much does a house slab cost in Melbourne?

A new house slab in Melbourne typically costs between about $110 and $180 per square metre installed, so a 200 m² single-storey home lands around $22,000 to $36,000 and a 150 m² extension around $17,000 to $27,000. The slab type (waffle, raft or stiffened), the soil classification, the site cut and the engineer's steel schedule set the number. We price from the engineer's drawings and the soil report and give a fixed written quote.

Prices on this page are indicative ranges for Victoria at the time of writing, not a quote. Based in Keilor East, Melbourne. Working across metropolitan and regional Victoria, New South Wales and South Australia.

What's in the price

A slab quote covers more than the concrete. The usual items on ours:

  • Set-out and site cut to the engineer's levels, with spoil removed.
  • Base: Class 3 crushed rock compacted in layers, plus sand where the design calls for it.
  • Formwork, vapour barrier, void formers for a waffle slab or beam trenches for a raft slab.
  • Reinforcing steel and mesh to the schedule, with bar chairs and tie wire.
  • Plumbing penetrations coordinated with your plumber before the pour.
  • Concrete to the specified strength (usually 25 or 32 MPa), pump, pour, screed and finish.
  • Curing, saw cuts where specified and the installation record for the building surveyor.

What moves the price up or down

  • Soil class: Class M or H reactive clay needs a stiffer slab, deeper beams and more steel than Class A or S sand.
  • Slab type: waffle slabs sit on the ground and save excavation; raft slabs are dug into it and cost more in labour but suit sloping or filled sites.
  • Site access: a tight inner-suburb block needs a line pump and smaller machines; a greenfield block does not.
  • Fall across the block: every 300 mm of fall adds fill, retaining or a step in the slab.
  • Finish: a plain screed under floor coverings is standard; a burnished or polished finish is priced separately.

Indicative Melbourne ranges

Planning figures for 2026, not a quote. Each one assumes the engineer's design is in hand and the site is reasonably level.

  • Single-storey home, 180–220 m², waffle slab on Class M clay: $22,000 to $36,000.
  • Rear extension, 60–100 m², tied into the existing slab: $9,000 to $18,000.
  • Double garage or large shed, 40–60 m², 125 mm slab with edge beams: $6,500 to $11,000.
  • Commercial or industrial slab, 150 mm plus with heavy mesh: priced per square metre on the drawings, typically $140 to $220.

Timeline

From the day we start on site, a standard house slab is about a week: two days of site cut and base, one day of formwork and steel, inspection, pour day, then a day for stripping and clean-up. The frame can go on after seven days; full strength is at 28 days.

Questions we get asked

Do I need an engineer before getting a slab quote?

Yes. The slab is designed from the soil report and the house loads, and the quote follows the drawings. We can recommend engineers and geotechnical testers if you don't have them.

Waffle or raft slab: which is cheaper?

On a level block a waffle slab is usually cheaper because there is less digging and concrete. On a sloping or filled block a raft slab often wins. Our waffle vs raft guide covers it.

Is the site cut included?

In our quotes, yes, because we do the excavation and the slab with the same crew. Check this on any quote you compare; it is the most common thing left out.